Jet 19 BM + BL-Motor 3500KV + Speed Control

Designed for small and medium boats.
The small jet develops tremendous feed with precise control of the model, both forward and reverse.
The jet is controlled by 2 servos
The set comes with BL motor and ESC

Recommended Accu LiPo 7,4V  (not included)

content
2 engine mounting screws M3x6 V2A
2 hinge screws for the reversing flap M1,6x4 V2A
4 fixing screws of nozzle M2,2x9 V2A
1 brushless motor 4.282135
1 BL controller 40A, G-Control 40
3 gold contacts for controller-motor connection
shrinkable tubing

Technical data Jet
Total length 128mm
Installation length approx. 80mm
Pave width 28mm
Height in the hull 36mm
Flange Ø rear 32mm
Impeller Ø 19mm
Nozzle opening 14mm
Motor mounting:
Bolt circle 19mm
Impeller shaft 3mm stainless steel
Storage: 1x ball bearing, 1 plain bearing
Clutch 3,0 x 3,17mm
recommended controller G-Control 40
suitable servos standard servo
                                 Mini servo

Motor

Operating voltage range 6-14,4V
Current consumption max. 40A
Power consumption idle. 0.2A
Revolutions / Volt 3500KV
Pole 14
turns 12
Timing 25 °
Shaft Ø 3,17mm
Free wavelength 16mm
Case length (magnet length)
32mm (21mm)
Case Ø 27.8mm
Weight approx. 60g

Speed control

Technical specifications
Current duration 40A
Current max. 45A (5sec.)
BEC 5V / 3A, linear
Voltage 6-12.6V with BEC, up to 19.2V without BEC
weight 35g
Dimensions 55 x 26 x 13mm
Max. Speeds 210,000 (2 poles), 70,000 (6 poles), 35,000 (12 poles) RPM
LiPo shutdown 2.9V / cell

When installing the jet in the transom, make sure that the centering flange for the exhaust nozzle is not ground off. It is then very difficult to center the impeller shaft.

Attention: Due to the small clearance between the housing and the impeller, the blades can break off.

Dry running can damage the rubber seal!