Electric windlass kit
Complete kit of a functioning windlass
This electric windlass lets an anchor of your ship model fall freely and slowly lift again. The windlass can be optionally built with one or two winch drums. The version with 2 drums is intended for simultaneous anchor dropping and lifting provided by two anchors. In the version with the large one-piece drum longer or thicker anchor chains can be used.
This is controlled via a proportional channel with a servo that holds the armature in zero position, pulls up the armature in one direction and disengages the gear motor in the other direction. A slip clutch ensures that when an anchor is hooked or high up, nothing can happen if the engine is not switched off. In your ship model, the winch is mounted below deck. It can also be used for other wind activities on ship models.
The winch is delivered as a mounting kit and is completed in 2-3 hours. It consists of plastic parts, gear motor, a servo, switches, parts for the clutch and all screws, small parts and detailed installation instructions.
Width over all 60 mm
Length 130 mm
Height 60 mm
Weight cpl. about 140 g
Operating voltage 6V
The kit of windlass with the order no. 63512 replaces anchor winches with order numbers 65210 and 65211.